Question the ring of power

Hi.
(mach3 and stepcraft 420)
Here is my project. The ring of power (Loard of the rings)
first i drawed the shape in Aspire. (here is the difficult part:( )
then i engraved it on an acrylic board (mach3 and stepcraft 420)
and then i lighted it up with a blue high power led with 2 batteries AAA size and
a tiny switch.
and that's all.

Hi,

this is really cool, i am looking for the elf writing, but i did not find anything,
Is it possible to send or post the dxf.

regards georg.

Excellent work! Thanks for sharing.

Cool thing,
Thank you for this nice inspiration.
@ angel_xt the same idea i´ve had 2 weeks befor. But i try to start milling with wood. It comes later. Did you use Aspire as trial-version or full-installation?

@Georg Surch in the net for FONTS and there you will find some differend kinds of this letters. If i find the link, i´ll send you later.

Greatings from germany
Frank

hi
thank you
I use the full Aspire version

hi
Ok i will send you the dxf file or gcode if you prefer.
just give me your email account
you have to use a 30 degree 0.1mm engraving tool
the working depth must be at -0.1mm (Z axis) at a speed of 20mm/sec
take care of acrylic melting because of temperature

Nice job! Could you give us the details which milling bit and speed you used for this job?

hi
thank you.
working rate 20mm/sec
rev/min = 12000
dremel 300
engraving bit: 3.175 30degree angle 0.1 mm
working depth 0.1mm or 0.2. Not more.
acrylic width = 5mm
if you have more information about this work do not hesitate to write me.