Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
Benachrichtigungen
Alles löschen
Show us your Stepcraft Creations
8
Beiträge
5
Benutzer
0
Likes
3,633
Ansichten
Themenstarter
Hi.
(mach3 and stepcraft 420)
Here is my project. The ring of power (Loard of the rings)
first i drawed the shape in Aspire. (here is the difficult part:( )
then i engraved it on an acrylic board (mach3 and stepcraft 420)
and then i lighted it up with a blue high power led with 2 batteries AAA size and
a tiny switch.
and that's all.
Veröffentlicht : 31/01/2018 12:45 am
Hi,
this is really cool, i am looking for the elf writing, but i did not find anything,
Is it possible to send or post the dxf.
regards georg.
Stepcraft 840/2, Eigenbau Steuerung mit WinPC-NC USB Modul, ESTLcam, QCAD oder TurboCAD V17, Fusion 360 als CAD/CAM
Veröffentlicht : 31/01/2018 11:04 am
Excellent work! Thanks for sharing.
MfG
Roy
SC 600/2; SolidWorks; UCCnC und UC100; EstlCam und Arduino Steuerung; KRESS 800kfme;
Veröffentlicht : 31/01/2018 12:13 pm
Cool thing,
Thank you for this nice inspiration.
@ angel_xt the same idea i´ve had 2 weeks befor. But i try to start milling with wood. It comes later. Did you use Aspire as trial-version or full-installation?
@Georg Surch in the net for FONTS and there you will find some differend kinds of this letters. If i find the link, i´ll send you later.
Greatings from germany
Frank
Veröffentlicht : 31/01/2018 3:24 pm
Themenstarter
hi
thank you
I use the full Aspire version
Veröffentlicht : 04/02/2018 7:57 pm
Themenstarter
hi
Ok i will send you the dxf file or gcode if you prefer.
just give me your email account
you have to use a 30 degree 0.1mm engraving tool
the working depth must be at -0.1mm (Z axis) at a speed of 20mm/sec
take care of acrylic melting because of temperature
Veröffentlicht : 04/02/2018 8:16 pm
Nice job! Could you give us the details which milling bit and speed you used for this job?
Stepcraft 840/2
UCcnc 100
Parallel port
Kress FME-Q 800w - Dremel 300
Aspire 8.5 software
From Belgium
supplier : Sorotec Germany
Veröffentlicht : 05/02/2018 5:22 pm
Themenstarter
hi
thank you.
working rate 20mm/sec
rev/min = 12000
dremel 300
engraving bit: 3.175 30degree angle 0.1 mm
working depth 0.1mm or 0.2. Not more.
acrylic width = 5mm
if you have more information about this work do not hesitate to write me.
Veröffentlicht : 05/02/2018 10:46 pm
