- Posts: 28
- Thank you received: 31
Question
Celtic Cross
28 Dec 2014 16:35 #12671
by woodendonkey
Donald
Learning from mistakes until I become an expert!
This message has an attachment image.
Celtic Cross was created by woodendonkey
This was my first piece after building SC600 - not counting the abandoned works while tuning the Stepcraft!
SC600
HF350
1/8" 60deg V-bit
1/8" spiral up-cut
9mm plywood
The up-cut gave it a fuzzy edge that I gave a quick rub with (very rough) sandpaper. Intended as a throwaway piece but my wife took a liking to it and asked me to make a stand to go with it. The stand took me longer to make than the cross - failures of a newbie.
Donald
SC600
HF350
1/8" 60deg V-bit
1/8" spiral up-cut
9mm plywood
The up-cut gave it a fuzzy edge that I gave a quick rub with (very rough) sandpaper. Intended as a throwaway piece but my wife took a liking to it and asked me to make a stand to go with it. The stand took me longer to make than the cross - failures of a newbie.
Donald
Donald
Learning from mistakes until I become an expert!
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.
28 Dec 2014 17:50 #12674
by MagIO2
SC 420 mit DIY parallel +Proxxon mit Mod + HF500 + SprintLayout + LibreCAD/QCAD + FreeCAD +WinPC starter/USB->EstlCAM + EstlCAM LPTAdapter + EstlCAM Handrad + DIY Vakuumtisch
Gruß, Andreas
Replied by MagIO2 on topic Celtic Cross
Very nice first try! So, we can expect to see some real masterpieces from you once you feel familiar with the steppi 
SC 420 mit DIY parallel +
Gruß, Andreas
Please Log in or Create an account to join the conversation.
28 Dec 2014 17:58 #12675
by Rory
Replied by Rory on topic Celtic Cross
Very good demonstration of what Vcarve Can do when coupled to the SC 
Very impressive first efforts. keep up the good work.
Very impressive first efforts. keep up the good work.
Please Log in or Create an account to join the conversation.
28 Dec 2014 18:05 #12676
by woodendonkey
Donald
Learning from mistakes until I become an expert!
This message has an attachment image.
Replied by woodendonkey on topic Celtic Cross
Thanks Andreas - no pressure, eh?
Second project (still on the Celtic theme) - coasters! Two still to cut
Second project (still on the Celtic theme) - coasters! Two still to cut
Donald
Learning from mistakes until I become an expert!
This message has an attachment image.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.