- Posts: 2607
- Thank you received: 791
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Sickone4 wrote: Hi Helmut,
was mir nicht ganz einleuchtet sind die Bogunrgen in der original PDF. Die Original Ersatzteile haben M3 Zylinderschrauben für die Rollenspannung einzustellen. die Bohrungen sind laut der Original pdf von Emaxxx 3,1mm. Das passt nach meinem Wissen jetzt nicht wirklich zusammen. Wie hast du das gelöst?
Zudem frage ich mich, wie das mit den Madenschrauben funktioniert. Im Moment ist ja die Spannung durch die U-Scheibe/den Zylinder der Zylinderschraube als Gegenlager gegeben. Wie ist das denn jetzt? gehen die nun durch den Laufrollenhalter und drücken statt zu ziehen?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
Danke, hab ich glatt übersehen.Sickone4 wrote: Ich glaube da passen die Linsenkopfschrauben rein von den X/Z Motoren
Please Log in or Create an account to join the conversation.