- Posts: 1
- Thank you received: 0
Question
Problem with 4th axis UCCNC setup
- kristoffertrix
-
Topic Author
- Offline
- Forum Nutzer
-
Less
More
15 Aug 2023 08:16 #63295
by kristoffertrix
This message has attachments images.
Problem with 4th axis UCCNC setup was created by kristoffertrix
Hello
I have an issue controlling my Stepcraft 4th axis in UCCNC. The A-axis keeps spinning even though it should only rotate 360 degrees making the A axis in UCCNC count below -1400.
When I adjust the Steps pr. unit to 30 it seems to solve the problem (then a full rotation axis a = 360 units i UCCNC). That said I am a bit unsure if that is the right way to solve the problem?
Do you know if the the problem is in UCCNC or it a hardware problem? I have attached a picture of the print card.
I look forward to hear from you.
Br. Kristoffer
I have an issue controlling my Stepcraft 4th axis in UCCNC. The A-axis keeps spinning even though it should only rotate 360 degrees making the A axis in UCCNC count below -1400.
When I adjust the Steps pr. unit to 30 it seems to solve the problem (then a full rotation axis a = 360 units i UCCNC). That said I am a bit unsure if that is the right way to solve the problem?
Do you know if the the problem is in UCCNC or it a hardware problem? I have attached a picture of the print card.
I look forward to hear from you.
Br. Kristoffer
This message has attachments images.
Please log in or register to see it.
Please Log in or Create an account to join the conversation.