- Beiträge: 15
- Dank erhalten: 0
Frage
UCCNC go to position
- Edinnit
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
16 Nov 2016 16:36 #39487
von Edinnit
UCCNC go to position wurde erstellt von Edinnit
Hi guys.
Sure I've missed something here, but is there any way you can enter in a location on your board for example X-10 Y-40 and the machine drives there?
I want to manually mill some bits, but will need to drive Z to the same position every time and I can't do that when jogging even at 1% speed...
Cheers
Sure I've missed something here, but is there any way you can enter in a location on your board for example X-10 Y-40 and the machine drives there?
I want to manually mill some bits, but will need to drive Z to the same position every time and I can't do that when jogging even at 1% speed...
Cheers
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- Edinnit
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
- Beiträge: 15
- Dank erhalten: 0
17 Nov 2016 00:23 #39498
von Edinnit
Edinnit antwortete auf UCCNC go to position
Found it, MDI commands
Bitte Anmelden oder Registrieren um der Konversation beizutreten.