- Beiträge: 14
- Dank erhalten: 0
Frage
UCCNC & meshCAM G-cod mix up
- clive 23
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
09 Jul 2016 00:51 #35664
von clive 23
UCCNC & meshCAM G-cod mix up wurde erstellt von clive 23
Hello
I I'm using a stepcraft-600 with designspark mechanical for designing and meshCAM with UCCNC, And i have run into an issue of file compatability between meshCAM and UCCUC. My question is what file type should i bee saving my files as.
I I'm using a stepcraft-600 with designspark mechanical for designing and meshCAM with UCCNC, And i have run into an issue of file compatability between meshCAM and UCCUC. My question is what file type should i bee saving my files as.
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- Doug
-
- Offline
- Forum Nutzer
-
27 Okt 2016 18:33 #38676
von Doug
Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), dsgb.net
Doug antwortete auf UCCNC & meshCAM G-cod mix up
I'm also using MeshCAM. Did you resolve this Clive?
I save my toolpaths in the "Basic G Code mm arcs" format but I haven't tried to run any of them yet.
Doug
I save my toolpaths in the "Basic G Code mm arcs" format but I haven't tried to run any of them yet.
Doug
Stepcraft 2/840, StoneyCNC industrial HF spindle, 4th axis, TurboCAD 2016 Professional 64 bit, MeshCAM, GWizard feeds & speeds calculator, UCCNC
Hobby use: guitar building (luthiery), dsgb.net
Bitte Anmelden oder Registrieren um der Konversation beizutreten.
- clive 23
-
Autor
- Offline
- Forum Nutzer
-
Weniger
Mehr
- Beiträge: 14
- Dank erhalten: 0
28 Okt 2016 00:11 #38692
von clive 23
clive 23 antwortete auf UCCNC & meshCAM G-cod mix up
Hello
I am useing basic G now to . I done software updated it seems to be going well so far
I am useing basic G now to . I done software updated it seems to be going well so far
Bitte Anmelden oder Registrieren um der Konversation beizutreten.