Xavier Le Terrier
@xlt
Active Member
Beigetreten: Jun 30, 2018
Last seen: Aug 2, 2021
Themen: 2 / Antworten: 6
Antwort
is there a buffer memory on stepcraft D series ?

thanks for your reply Rory. I have near zero backlash with my stepcraft. once, accuracy issue was caused by poor tension of the belt. i fixed it, chec...

Vor 6 Jahren
Antwort
upgrading my 840-2 with a laser engraver?

good morning, I’m’looking for to upgrade my 420 too with a banggood laser. problem with the stepcraft genuine laser is that it is not powerfull enough...

Vor 6 Jahren
Forum
Antwort
Control board LED 2 is off, the router does not start

good morning. did you check the emergency button (red) in front of your lachine ? perhaps it is engaged. disengage it best regards

Vor 6 Jahren
Antwort
Holes and circles are leaning left, making more of an oval

Hi guys, I fixed this issue. If your controller has a buffer feature, check it and activate it. My Stepcraft works with an AxeMotion Pulsebox NXTG us...

Vor 6 Jahren
Forum
Antwort
is there a buffer memory on stepcraft D series ?

I answer Myself : No. There’s no buffer memory on Stepcraft D series. BUT int the usb module (I own an AxeMotion PulseBox NXTG), there is a 400 vector...

Vor 6 Jahren
Antwort
Holes and circles are leaning left, making more of an oval

Hello, I’m a french user. I bought a brand new Stepcraft 2/420 and I have the same issue. I have to say that my Stepcraft is very well tuned (all axis...

Vor 6 Jahren
Forum
Topic
Replies: 0
Views: 3218