I bought a selection of 300mm x 210mm (roughly A4) from metaloffcuts.co.uk Brass Sheet Metal 300mm x 210mm x 0.5mm Brass Sheet Metal 300mm x 210mm...

What feed rates are you using? I went to 1mm pass with 3mm due to a number of crashes (lost steps in Y, tried to run across the work piece 7-8mm deep...

Hi David I run a Stepcraft 600 from a laptop using UC100 controller (USB connection) and UCCNC software instead of Mach3. I'd advise you to take...

Hi Leo The main thing for me getting the HF spindle was that it takes cutters up to 8mm shank diameter, so you can get bits with 1/4" shank that ar...

Thanks Andreas. I was concerned that with one hand holding the spindle lock button in (HF350 spindle) and the other turning the spanner, I have no ...

VCarve Pro from vectric.com

90degree 6.4mm (Dremel bit no. 640)

Thanks Andreas - no pressure, eh? Second project (still on the Celtic theme) - coasters! Two still to cut 🙂