For anyone looking at this in the future, this board is the enclosure main board. I've attached the wiring diagram from the Stepcraft manual for those...

Hi Kishmul, That's really annoying. I too spent ages setting up my laser and still it's not working correctly (homing pin does nothing, no "sight" ...

Hi Kishmul - sorry for the delay. Did you get sorted?

Thank you bmartens! This is very helpful!

Hi All, I had exactly the same issue. I got my HF 500 second hand so not much chance of warranty in my case. So I set about repairing it myself. Ve...

YOU WERE RIGHT! Thank you so so much. I have wasted hours on this issue. And thank you to dezsoe on cncdrive. I am still having issues with the pro...

Hi Andileibi, Thank you for the reply. However, I think it is a different issue as I can set the current hi/low on the i/o setup page. I am using t...