Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
![Thomas Hartl Thomas Hartl](http://stepcraft-systems.com/wp-content/uploads/wpforo/avatars/Voltatus_29300.jpg?lm=1721160487)
Thomas Hartl
@voltatus
Trusted Member
Beigetreten: Apr 29, 2015
Last seen: Sep 14, 2020
Last seen: Sep 14, 2020
Follow
Antwort
Fräsbox, Einhausung, Lärmschutz, Staubschutz,.....
Hallo, seit heute ist es vorbei mit der Freilandhaltung für meine Steppi. Die Kleine musste in die Kiste:
Vor 9 Jahren
Forum
Antwort
A few questions from a non stepcraft owner
No, the Stepcraft USB Module works only with WinPC. For UCCNC you need an UC100 USB motion controller and the Stepcraft Parallel Module. Bit there are...
Vor 9 Jahren
Forum
Antwort
Aufbau Stepcraft 2 600
Im Verlauf des Aufbaus stellte sich jedoch heraus, das die Kabel vom Z-Motor zu kurz waren. Hier musste ich die 4 Kabel um 500mm verlängern! Das g...
Vor 9 Jahren
Forum
Topic
Antwort
USB oder Parallel für 3D-Druck
moin, wenn du winpc-nc nicht nutzen willst, dann kannst du mit dem usb-modul nix anfangen. es fungiert als hardware-dongle für die software. Danke...
Vor 9 Jahren
Forum
Topic
Seite 6 / 6
Vorherige