I'm the 'proud' owner of a Stepcraft 840/2 since may last year. So far, i've managed to finish 2 jobs and ever since, my stepcraft is disfunctioning. ...

after a week thinking about it, what could go wrong, i just gave it another go... all went well... untill some 50.000 lines further... again, the same...

I made some progression. I exchanged the wood burning pen for a router and tried various things from the Aspire software. i still have an awesome lot...

Yeah, i've noticed that, but since the beer openeres had to be engraved with the same font like the other stuff i had already, it had to be a specific...

Hi Ludo, where can i find that book? Could you give me the link of the webshop?

Hi Ludo, thanks for the advice. I finally got the machine running. i discovered that the Y axis were not parallel aligned after tossing the port...

Unfortunately i keep facing problems before i can start with my 'Referenz-run'. The Z and X axis can run from end to end, but my Y-axis keep stalli...

Amazing... i posted a message on the Sorotec facebook Messenger arround midnight on the Easer holiday and i actually got response minutes afterwards.....