wit gelakte MDF hardboard van 3 mm (standaard te koop in Hubo / Gamma)

Nice job! Could you give us the details which milling bit and speed you used for this job?

about 4 hours, due to the low velocity my configuration is working at.

i know, but since i have been struggling so much with the stepcraft assembly, i refused to invest any more money and that Dremel setup wasn't meant to...

Hi Doug, indeed, because mine isn't that well outlined i had to lower the speed to a shameful 1000 mm/min, but at the end of the day, my Stepcraft ...

I tried to play a bit with the velocity in UCCNC, after switching my heavy Kress 800 spindle for a little Dremel 300 which was laying around in my wor...

Hi Gary. I have a 840/2 just like you and have the same issue. I presume that your problem is a loss of steps, somewhere, somehow and problably you w...

after reassembling the machine bit by bit, according to Rory's video, now i have soms issues with the Z-axis. Would there be a specific video on how t...

i followed the 2 videos from Rory step by step for the X and Y axis, but now it seems i have problems with my Z-axis... thanks to the videos and th...