simon
simon
@unclebuck
Active Member
Beigetreten: Nov 7, 2016
Last seen: Mai 1, 2020
Themen: 0 / Antworten: 8
Antwort
Milled circuit board with SMD components.

i managed to get the 840 here to happily go down to 0.5mm pitch for a fpc link board and a custom pci-e card and circuit used flatcam to process the b...

Vor 7 Jahren
Antwort
PCB engraving with VFD spindle

I use the big 840 here for milling my pcb's i use altium and eagle spit them into flatcam do the copper removal set up and then get extra fine pcb mil...

Vor 7 Jahren
Forum
Antwort
840 almost there but white baseplate problem

I would like to concur with the above two statements because i like Fish finger sandwiches.

Vor 8 Jahren
Antwort
Really struggling....

Hi Pete forgot to mention, before sliding the t-bed in i applied 3 in 1 light machine oil in the channels using a cloth with a good amount of oil on i...

Vor 8 Jahren
Antwort
Cusom Enclosure CAD -- Rough 3D models?

Welcome to the forum! And just an answer ... are you serious? Open a CAD software, draw 3 squares, pull, DONE! Takes longer to write down the q...

Vor 8 Jahren
Antwort
Really struggling....

Hi Pete. We had slight issues with our 840 here with the aluminum t-bed. After much head scratching we took the end plates off and re adjusted t...

Vor 8 Jahren
Antwort
How do you clean the screw rods??

i just spent two days cleaning and servicing our S840. i use blue rip paper towel off a roll, and then run the machine in fast travel back and forth h...

Vor 8 Jahren
Antwort
UCCNC autoleveler plugin

Hi we have a stepcraft 840 here and use the autoleveller all the time for milling pcbs. we are using the latest version of uccnc with the autoleveller...

Vor 8 Jahren
Forum