Tommy Friis
@tommyf
Eminent Member
Beigetreten: Nov 8, 2018
Last seen: Jan 28, 2019
Themen: 5 / Antworten: 34
Antwort
Grounding of the system

I guess, any point on the metal case inside the cnc would be a ok point to connect the ground? i wonder since it kinda like small round holes in my g...

Vor 6 Jahren
Forum
Topic
Forum
Replies: 0
Views: 4860
Antwort
New here!!!

Which CNC?? if Stepcraft you can only get it from there's official sitet as i know...

Vor 6 Jahren
Antwort
Play in Y axis - Ordered replacement nuts

Nice, thx mann.. my 420 is new, but nice to know anyway...

Vor 6 Jahren
Antwort
What router to choose? AMB (kress) 800/1050 or MM-1000

I test more here, actually put 2kg on the Z axis, abs no problem, up and down like a dream, my problem was a noise isolating layer under the SC420 the...

Vor 6 Jahren
Forum
Antwort
New here!!!

Error found, me,,, cnc was a foam plate to min noise,,, that gave sherness and lockup axis,,, no problem now...

Vor 6 Jahren
Antwort
New here!!!

Well,,, now i am unhappy,, since Stepcraft sell Kres on there website i assume 420D could run with one,,, but ffs, my 420 can raise the motor... Th...

Vor 6 Jahren
Antwort
What router to choose? AMB (kress) 800/1050 or MM-1000

Hey,,, i got a Kress 1050 FMe1,,, i have a little worries about the weight(1,7Kg),,, can my V2-420D cope with it, or must i get a minor one?

Vor 6 Jahren
Forum
Antwort
New here!!!

Can say i am not unhappy with it, it is already now big step ahead in precision that my 4030 Estcnc ever was...

Vor 6 Jahren
Antwort
UC CNC - Autoleveler Plugin, Digitizing

OFC i have,, Stepcraft forum!! they dont HAVE to, but really,, they should care,,, well my mistake then to think they would look here to help costumer...

Vor 6 Jahren
Forum
Antwort
Cold or not

Well, my dealer say a least 18° thats bad for i have no heating possibilities in that room.. oh well, run it must wait to next summer then..

Vor 6 Jahren
Forum
Topic
Vor 6 Jahren
Forum
Replies: 3
Views: 3932
Antwort
Play in Y axis - Ordered replacement nuts

Do you mind link to them 🙂

Vor 6 Jahren
Antwort
New here!!!

I got the ready version 420,, for me it just about learn CAM and get it out into reality with help from the 420, but 100% fun and interest... a bit mu...

Vor 6 Jahren
Antwort
UC CNC - Autoleveler Plugin, Digitizing

Wake up SC, one should think one can get a answer here....

Vor 6 Jahren
Forum
Seite 1 / 3