Is universal lithium-EP grease NLGI-class 2 good for the Stepcraft machine or does it have to be a lighter class grease? Personal experience and so...

Is it not disappointing that stepcraft 2 is not with Nema 23 motors, but again with the weaker Nema 17 motors? It kind of seems so. At first I got ...

Thank you for answering Rory. I was a little worried about the pattern seen on the roller.

I`ve said it before, but the Operating Instructions state that you should work using milling cutters with a diameter of up to 3mm, so you might attemp...

Hi, Some technical information can be found under this page: Prices vary vrom shop to shop, but for reference: Maybe you could ask for a cu...

Found some technical specs under this topic (scroll way below):

Yes, the UC100 is connected to the parallel port of the SC840 and UCCNC is installed on my PC. I have successfully installed my license file, the soft...

Thank you for your answers so far. Here is something I am looking for, but I would like to see a bigger selection of alloys and tempers: . Mainly look...

Probably this depends on the kind of aluminium you cut. I cut all aluminium dry so far, without problems. So the obvious question: what kind of alu...

First experiments with devCad Cam Pro (spars) and devWing Cam (airfoils) programs: devWing Cam screenshot Airfoils are cut out from 1,5mm an...

Hi Jomule, I have milled 16mm mdf. Here are the facts: SC 600, Dremel 300, 3,175 diamond mill (Fräser), 12 mms, 30000 rpm (This is the maximum spe...

Dear all, Maybe I did not read everything on the forums so far but the thumb rule of not going deeper than half of the diameter seems to be very, v...