Maybe it is a resonance issue, something like described here. 3D printing shouldn`t create much load on the machine, maybe this contributes to the pro...

What feedrates, I mean what values are we talking about? If slowing down helps, a mechanical issue seems probable IMHO.

Unfortunately my Proxxon died on me and I was left with the inevitable question of whether to simply replace or upgrade. ... Any idea what happened...

Examples of finished battery boxes in some of my models: Mounted with superglue or with an aerosol construction foam.

I changed my grease to Mannol 9985 Li-EP 00/000 Low Viscosity Grease about a month ago. Seems better than thicker grease because it stays on the surfa...

There are threads in this forum where people write about their experience. My experience is also all here, if I do something new, I`ll make a post. Th...

Hi, ... Once I have some familiarity with the machine I want to use MACH3 on a laptop with a parallel port and running Windows XP. Does this mean th...

Very nice craftsmanship. Isn`t debris going to cause problems when getting into that open motor casing?

Did you tighten the screws as described in First Steps document available on Stepcraft homepage (Service and Support)? Are the portals the same length...

Maybe this will help: building tips video Also don`t forget the "First Steps" document on SC homepage.

Let me quote some more. 🙂 Another good point - very important to verify the free movement of the machine in all areas of travel - but in thi...

One of the reasons I used a custom profile was that I had a slight problem with homing. Using the homing speeds in the default 600 profile the axis ho...

Don`t have any solutions, but couple of ideas. The following information could be completely irrelevant in this case. I see you have a laptop with ...

... question I have is how tight to make the belt? Stepcraft V1 building tips video.

Remembered that there already is a topic for discussing lubricants so jumped back to this thread. 🙂