You could try a dry-run and see if machine runs smoothly or it gets stuck. If no mechanical problems then maybe try again with other cutting parameter...

I think Stepcraft 1 models and 210 has 200 steps per unit. As described here

Hello, My question: Is there a way to compensatie this constant height difference in the software ? My quess would be in "Parameters" --> "Machi...

Just purchased one of these, it works well but seems to lack suction. Plus the colour matches my stepcraft 🙂 What is that exactly?

Did you check the following topic: here. Does it make any particular sound when it gets stuck?

For example: "practical for the machine", "sufficiently detailed" and "a few Euros" are very subjective. If there's an awful lot to learn then there's...

Would like to see some information about cutting data (mill bit diameter, rpm, feed etc). have you tried cutting with a slower feed?

It sounds like your Y axis is jogging. Did you adjust every axis as the manual indicates? I would remove the floor and run the program again so you...

... Rather than moving to the first cut path, it just starts cutting as soon as it begins. ... Did you zero the machine coordinates according to...

Maybe there is some useful information on the following CNC Cookbook links: link 1 link 2 You might have to fight some advertising banners when ope...

I use dry Katrin Plus Poly cleaning "towels". I cut one large sheet into several smaller ones and clean the threaded rods, guiding rails etc with them...

The Z axis, if you enter a hard material at a certain speed, the motor will be forced for a while and will lose steps in each pass. I'm adding ramp...

I tried cutting hard wood at 3mm depth and my Z axis lost a lot of steps. Definitely not trying that depth again. ... Sorry but that doesn`t make mu...

One more thing to consider when living in an apartment building is the vibration that is carried through solid structures in contact with the machine....

Didn`t find that in my SC1 manual. Haven`t used homing once yet, if I understand correctly then some people set soft limits in relation to the homing ...