Hi Speedo, yes, its a big improvement - materials much longer than the bed (typically 900 - 1200mm) are no longer a problem -I was always watching th...

Hi all, Think I’ve got to the bottom of the undersize circle problem with Stepcraft starter software, using .plt files. Here’s the problem – the sof...

Thanks, will check the set screws. Have had problems in the past with pulley screws loosening - 3 mm is not big enough - if they come loose again - w...

Hi all, Have looked at Estlecam download - but it will only accept .dxf files - not HPGL which I would need. However, it certainly looks like tool pa...

Hi all, thanks for prompt replies. The Estlcam software seems good value & I will probably go that route. Could I ask the following - I like 'tur...