Simon Lister
Simon Lister
@sonny
Eminent Member
Beigetreten: Nov 2, 2015
Last seen: Feb 5, 2021
Themen: 8 / Antworten: 8
Topic
Forum
Replies: 0
Views: 2296
Topic
Forum
Replies: 0
Views: 94
Antwort
Scoring on the rollers and rails

I gave the areas a good clean to remove all the grease and then rubbed over the area with some fine crocus paper to remove any ridges. I also replaced...

Vor 4 Jahren
Topic
Replies: 0
Views: 136
Antwort
How to align a workpiece to Y & X axes ?

Sorry about the late reply, we had a death in the family. I have never used the M keys but will look at it today. Many thanks and Happy New Year.

Vor 4 Jahren
Forum
Topic
Forum
Replies: 2
Views: 2199
Antwort
Again with a Z Axix problem

Hi Erik, Its a small world I was a ASW Specialist also then went SD and did the same job for the rest of my time. The only thing I can think of ...

Vor 4 Jahren
Forum
Antwort
Again with a Z Axix problem

Hi Erik, General Service eh! I have probable viewed you through the peep stick at some time during our service! Thanks for your comprehensive re...

Vor 4 Jahren
Forum
Antwort
Again with a Z Axix problem

Hi Erik, I did 37 years left in 2014 but still involved with the sleek black messengers of death. Were you a Submariner, you didn't actually say? ...

Vor 4 Jahren
Forum
Antwort
840 Performance Kit limit switch issue

Morning, You are of course perfectly right, and it is a waste of time to verbally assault my machine........but the wife fights back! Regards.

Vor 4 Jahren
Antwort
Again with a Z Axix problem

Good morning CNCMiller, Thanks for getting back to me. Good catch with the Submariners Badge not many would pick that up, and the use of target ...

Vor 4 Jahren
Forum
Antwort
840 Performance Kit limit switch issue

Hi CNCMiller, Yep you were right. After all my checking and 'tweaking' I did not do the one thing I should have though of first, I should have just...

Vor 4 Jahren
Topic
Forum
Replies: 10
Views: 4690
Topic
Replies: 4
Views: 2720
Topic
Replies: 3
Views: 2728
Seite 1 / 2