It is with all axles. Homing jogging again solves the problem from where I'm stuck, but then it gets stuck on another point. I don't think it is the s...

No, it isn't counting. But I also don't think it is stuck because when I restart my computer I can go further from that point.

Uccnc with cut 2d

I found the problem... I had the settings set at a 3mm drill. But i used a 2mm drill. How do you keep them separated? I have no tool to measure good ...

Ok, so i need to fix the play in the Z axis. I will try that (i was hoping it was a setting).

I have a little play in the endmill. but how come all the lines are good and it only plunge off it own line?

It worked, that did the trick! First time it got stuck half way and shifted... But that is maybe the wood or my essembly. I'm pleased with the firs...

I clamp the wood with the supplied iron bars. But have not found the perfect clamp method for thicker wood jet. I used the settings from this post:...

So i found the settings and set it just like you said (still very fast in my opinion). But i found a new problem (or the same was before), it doesn't ...

Nope, maybe the board was not straight of shifted a bit. Next week I will try different boards and shapes. Maybe it will solve on its own.

Succes! Thank you sooo much. Only im not so happy with the result. I draw a 100mm round but 10% is off, it looks like it is shifter after the first ro...

Thank you so much. I will try Monday and let you know

Strange, I didn't. Is there a way to work around. Is that the same as loading a profile?