Thanks, Peter. I am up and running on the new Lenovo M700 (after having disabled the Microsoft check for drivers that are not WHQL certified). Not s...

I am sorry I was so quick to close this thread, thinking all was resolved. After purchasing a small, dedicated PC (Windows 7 Pro, plenty of memory, e...

Forum moderator may choose to delete this or leave for others. I was able to resolve the issue(s) before first response: Turns out it's all about di...

Gerry and Roy: Since we are in disparate time zones, I almost had this resolved before seeing your posts this morning. Short answer - I failed to thi...

Gerry and Peter: Thanks to both of you for quick response. Perhaps I didn't give UCCNC a fair trial before thinking there was something better. May...

Thanks again, Peter. You confirmed what I thought, but was unsure. Here is a link to what I think might be a good solution, not too costly unknown i...

Peter - I feel like such a floundering newbie, thanks for your patience. I (wrongly?) assumed that the tool length sensor only shows depth, NOT where...

Pitch: Your experience is much the same as mine, as my US distributor assured me assembly would be "no problem". Fortunately, as you see from Thomas...

I would have started a new topic, but the thread seems to be much like my problem: Designed several geometric shapes in Vectric's VCarve Pro, to be c...

Norbert: You may receive help from forum members with more experience than me, but this I can tell you... The fact that you could produce what appea...

DerRoy: I always "sit up and pay attention" when you lend your expertise. This subject (orientation/position) is just what was giving me grief. I w...

Forgive me if this sounds too simplistic, but the same thing happens to me - WHEN running UCCNC without being attached to the controller. I have crea...