s cutty
@scutty
Active Member
Joined: Dez 8, 2022
Last seen: Jul 15, 2023
Topics: 2 / Replies: 7
Reply
MM-1000 DI spindle HELP!!!!!

That looks right. I have found the circular connector on the top of the spindle is also not robust. Suggest checking that end as well.

1 Jahr ago
Forum
Reply
How do you access the relay outputs?

Apparently this is not something that is supported according to SC tech support. Fortunately UCCNC is supper customizable. Relay one is going to the ...

2 Jahren ago
Topic
Replies: 3
Views: 1514
Reply
jog pendant

This is super helpful. Thanks for taking the time to share. For the game pad will any of the many options on amazon work the same? or are there specif...

2 Jahren ago
Reply
jog pendant

That's interesting. For me I put a high priority on customization and learning. I want to be able to put switches in space where they make sense to me...

2 Jahren ago
Reply
jog pendant

This project ended up easier than I thought. Turns out the Due, Seeedstudio XIAO and a few others have built in keyboard and mouse emulation. In other...

2 Jahren ago
Reply
MM-1000 DI spindle HELP!!!!!

I recently got a D3 with the MM100DI spindle and had a similar problem. I could run it manually without the cable attached but it would not work at a...

2 Jahren ago
Forum
Topic
2 Jahren ago
Replies: 6
Views: 1499
Reply
Y Axis not working

I'm new to SC and UCNC. I got tripped up like this a couple times during set up when the system was beyond the soft limits. Did you check that your li...

2 Jahren ago