Ionut Bornoiu
@screamer2703
Active Member
Beigetreten: Jun 6, 2014
Last seen: Jun 17, 2014
Last seen: Jun 17, 2014
Follow
Antwort
Stepcraft 600 4th axis problem
After a few emails exchanged with Stepcraft Support and checking for solder bridges between connector pins, the WinPC-NC USB software started to recog...
Vor 11 Jahren
Forum
Antwort
Stepcraft 600 4th axis problem
Is there a pinout for the 4th axis motor connector available ?
Vor 11 Jahren
Forum
Antwort
Stepcraft 600 4th axis problem
Thank you for the information. I am starting to suspect the 4th axis motor. Problems arise only when the motor is connected. Is there a chance that...
Vor 11 Jahren
Forum
Antwort
Stepcraft 600 4th axis problem
Sorry for the double post. I am still convinced that the problem is on the software side. I connected the CNC (4th axis motor attached) to the com...
Vor 11 Jahren
Forum
Antwort
Stepcraft 600 4th axis problem
Hello and thank you for your advices. I have contacted Mr. Lewetz and after a few emails exchanged he pointed out that the problem must be on the h...
Vor 11 Jahren
Forum
Topic