Last seen: Jul 7, 2021
So i got some help from Stepcraft US. And the result is the jumper caps or terminators or whatever they are called do need to be put on the 4th axis b...
Is there an option to add this to the z axis?
Hi Doug, certainly in Australia it is also hard to find harder grade alloys in thin sheet. I have cut some supposed 7075 from china bought on ebay and...
Doug I had the same problem with some 5005 alloy,I think it is because of the softer alloy. I would definitely use an air blast of some sort to keep c...
Happy to share. Yes I had tried varying spindle speeds and low feed rate of about 130mm/min to 200mm/min but as you can see by the first picture it wa...
Hi, Interested to see you have milled an aluminium part successfully. I had a disaster on my first attempt and broke the cutter when everything ja...
Ok problem sorted, after running the calibration as suggested by cncdrive the issue was with the steps and it was at 200 and it should be 133.33. Afte...
Here I've attached 2 screens but they are taken from an old version 1.1019. So check if they work with your version but you can always download the c...
Thanks for the reply guys. My Profiletemplate.pro has this first lines as you have written [Screensetsettings] mainscreenfilename=Defaultscreenset ...
Well it seems I can get the file to read correctly when I don't use the stepcraft 420 profile in uccnc. At this moment not sure how to resolve this pr...
Hi sc, I fixed my issue by changing the UCCNC profile, it's nothing with Fusion 360 but how UCCNC read the file. To change it, go to configuration,...