Mike is correct - the soft limits are set relative to the homeing routine and are always the same. You cannot change the machine co-ordinates. Only ho...

It is. the update rate on the screen is very fast and the resource usage on the CUP is much reduced. We are testing on all our machines at the moment ...

IF you get the Tslot bed for the machine it stabilises the system significantly. The setup and tuning is largely down the first setup and once assembl...

As per above - its adobe / flash issue with latest update on windows causing some dekstop programmes to fail to launch. One of which is the UCCNC. ...

as per Tikkas link... just turn them off (button below the XZY readouts on front screen)... could be something funny with Z limits... but again - t...

For sure yes - possible.

you have to find the source of the friction? step by step bit by bit and test at every step.. do the leadscrews move freely in the brass nut? ...

disassemble and retune following the video steps. You should be able to run the machine at 4000mm/min for tests

>> config >> general settings >> enable soft limits (uncheck box) >>apply >>save >>close and re-open UCCNC t...

you should be able to move a well setup STEPCRAFT machine at 4000-5000mm/min rapid rate with smooth performance on all axes. Where does the issue ...

What is the status of the two green lights to the right hand side of the black power plug at the back (right hand side as you look at the back of the ...

Spray better in our opinion... it cleans also as it sprays and it doesn't attract as much dust etc... but needs to be done often. don't over grease th...

how are you holding the workpiece on the table? best depth results are reached if you machine the top of your spoil board flat with the machine. ...

How are you lubricating? Watch that the rollers are not recyling grease down into the spindle / nut interface (#14 and #59)