unlikely loosing steps if circles are round.. you post as Mach2/3 arcs mm and yet you mention you draw in inches? always draw in mm and post in ...

The pitch of the screws is the pitch of the screws. 133.333 is correct. you can't adjust the steps per unit based on measured dimensions like this...

top of toolpaths setting in the right hand side - there is a Z home figure. this will sort you out.

Hi Peter, when you are making new changes and new profiles the best method is as follows. >>config >>profiles >>list profil...

Thanks for the settings Alan! and the info on theh acrylic sheet!! very useful for other users. The high quality single flute down cut cutters spe...

They should transfer over fine Peter. you should not have to make new ones. But as ever - careful. We have profiles for V1.2 if you need help

Page up + page down for Z 🙂

Cool - the main reason for the isolation is to protect the chip from noise. The ETH side of the ETH module will protect your PC from any mishaps. ...

the UCETH is isolated on the Ethernet side. Not on the output side. So the isolation on the machine side is related to what optoisolators the drives a...

10 metre USB cable is too long. Any extension is not a good idea. The Ethernet connection using the ETH module is done using differential signals and ...

Mach2/3 arcs mm .txt is what you need.

the end condition on the non thrust side is not critical. All the thrust comes from the Stepper side. all that bearing has to do is keep the end of th...

you need a controller that supports Mach4 to use Mach4. Currently there are a lot of solutions for Mach3.. how much are guys getting a Mach4 li...

1.2016 is on the UCCNC site. 1.2016 has the open GL GUI.

if it runs in demo mode then it has not found the drivers. the UCCNC will tell you specifically if it cannot find the license key. you need a ...