to change direction of axis >>config >> pots and pins >> motor outputs >> change the "Dir LowActive" pin to opposite of wh...

Welcome to the forum Alex. Thanks for your contributions so far. They have been very helpful. Rory

Super - thanks for the file. IKEA - clocks are like 2£ 🙂 gut the cheapy plastic and use your creation. the clock in the video was made using a...

... we will open up a new topic referring to work holding. Nice idea - thanks for doing that! 🙂 Now for the German guys .... 😉 Für die...

Yes - but be careful as you cannot mill as hard when you use just the glue - there is still a risk it will shear on the glue line and move. You are re...

😉 Super job! lovely example.

3M photmount spray is good - we will open up a new topic referring to work holding. If you use a piece of ply/MDF as your base layer - glue this t...

Well done. you need to loosen the bolts holding the orange end plates to the aluminum profiles and run the portal up to the edge. What you should find...

I tend to do a row at a time with most of my projects and try to reduce the part from lifting up by having the clamps as close as possible. clampin...

We can't find the original file - but here is a DXF'd stopwatch file that you can work with. If you google "Clock vector" or "stopwatch vector" yo...

If you click the TAB key you will bring up the jog menu. I you have Mach3 open you should be able to jog with keyboard keys. This is the same as us...

Looks great! Much tidier than cable tie!

20mm/sec is 1200mm/min. We try to work in Metres/min and mm/min for the speeds. Thanks for sharing. Good work! Can we see some results? The d...

The PWM for the spindle output on Mach3 works by making the duty cycle 100% for full spindle speed and 0% for 0 spindle speed. The frequency can be...