The drives have a pre defined setting for the motors. The motors are the same The calibration for the ballscrews are the same. you need t...

plunge is the speed in the Z direction. feed rate is the speed in the X and Y directions. if you plunge too deep you will break tools. Also yo...

I want a reindeer....

Neil - Welcome to the forum. We look forward to seeing your creations.

Really cool! the finish is very nice... CNC is only half the story in that picture... The finish makes it!

hello - where did you get the profile for the UCCNC? can you send it to me? you can calibrate that out - but its unlikely its software. STEPCRAFT...

This is good to hear. Thank you.

Cool project!

You can - its on the list of things to do 🙁

If i buy the uccnc to i really need the uc100 adapter it looks like it converts from usb to pararell ! do i need an pararellmodule also i now hav...

Jorgen, we don't have the WinPC files - as we use UCCNC and used to use Mach3. If no-one posts here soon - I'll get STEPCRAFT to post the parame...

Okay - so you have an active installation of UCCNC - its important the UCCNC is not running in demo mode as this will not allow signals to get to the...

Hi there i have a s420, now trying uccnc , but dont seem to be getting the settings correct, is there a file like with mach3 xml this may make it e...