🙂 fine for demo and test - not essential to verify motion. once happy two inner fellas can be tightened with care.

Hi dear IGRAUDINS. !! Please you can give me more details, since I have problems in the Y axis, since I can not reach to any end of the Y axis, n...

Lost steps for sure - due to mechanical issues.

Lost steps for sure - due to mechanical issues.

Hold ballscrew with pliers / vice grips on inside (close to orange plate) see does the pulley move independent of the ballscrew. this can be a ...

Top stuff from Peter as always

you can change the settings. Y becomes Z. Z becomes Y. if you reverse the motion directions you don't need to mirror the toolpath like in that video ...

where did you buy your machine?

up to 1.1 its flash 1.2XXX is Open GL... much faster to respond.

Pass depth. drop that to 0.1 or 0.2mm and keep the feed high and you will see very different results.

Can you post a picture of the result from a circle?

Mach3 should work fine

important to know if its a "moving zero point" or "backlash"... does the Zero position stay the same? if yes... then its backlash if the z...

Jog machine to end of travel with the bolts holding the orange plates to the extrusions loose jog in and out right at the end of travel and careful...