Many thanks Rory, I have a number of questions, so I'll keep them to this thread if I may, rather than start multiple ones... The project I have in...

The clamps keep the top most surface that sticks up to a minimum. Give you access to almost all of work without interfering. was that part milled o...

Hi Huff, thanks for the question here. The motor is three phase - the motor driver systen is powered by single phase. So the standard supply will w...

Love the custom bed setup - and clamps.

Nice... tough work on Cut2D. Vcarve is the boyo for that Tug!

yes - you need to tell all CAM packaged what the cutting diameter of your tool is. And then put the correct tool in the machine. more high end CAM...

Likely to work really well.... 🙂 until you want to take her apart to service / rebuild!

typically - loctite is better as it can be reversed with heat. Super glue is not as easy to re-work with. The worst case scenario is when one can't ...

approx 500euro. cheaper to make one yourself. have you got any double glazing going spare? 🙂

you must "snap" the collet into the nut before you tighten. if you do not mount your tools correctly its lethal. the collet should "seat" / "snap" int...

Can you suggest where to move it to? MY German is not good :dry:

This is correct - the only difference is the travel size.