It is very important that the 4th axis does not "spool in reverse" when you control it. this will wind the filament in reverse and pull the plastic ou...

Very good demonstration of what Vcarve Can do when coupled to the SC 🙂 Very impressive first efforts. keep up the good work.

Well done. Yes the PWM signal frequency was too low. Careful as you now have to configure the spindle speed in the CAM software. The Gcode now con...

dropbox link Here are the Macros. There are two in there that should "zero" the A axis when the program starts and finishes.

We have made macros that zero the A axis before and after the program is run. to avoid spooling in reverse when the A axis goes back to "zero".

search bar on right. see image

Tug - can you post an example of your DXF files that you export from Illustrator? You can "right click" in CUT2D and "select all duplicate vectors...

nice work. 6k is quite low for the proxxon. its better to keep the RPM up higher. more torque. Try to go not so deep in the cut, move the machine fast...

good point - had not noticed that. will see what we can do.

The machine can come with WinPC starter. this must be used with Corel Draw (.plt files). This is not a Gcode controller. The WinPC starter card can on...

Proper job 🙂

Wow - keep us posted on this project!!!

Post away - you have a question? Chances are 8/10 have the same one. Post away!

Super!

A forum is more usefull if each topic/question has its own thread. Otherwise you'd have to digg into each thread to see weather your question has been...