The 840 is in demand 🙂 Good luck with purchase and be sure to share your creations !!

there are some reasons to prefere the Uccnc because its closer to fanuc and other prof cnc software then ncpc. Bruno Agree - the interface is very...

Schafft die V1 auch die KRESS 1050 FME-1? (Aufnahme, Kräfte...) thank you for message - please keep the English forum in English. The question ...

Great analysis. Yes the PLT files have polygon limitation - but not as much geometry as you have found. The settings will be correct for motion. ...

2mm and 4mm plywood in these sort of tests. - 1mm diameter 2 fluted carbide upcutter - these are very easy to break - make sure the part is wel...

Well done! Super work. You can apply the 3D toolpath in other directions. You look to have done the finishing toolpath at 45 degrees. You can do it at...

Rory, In another thread you said "The STEPCRAFT HF spindle is a great addition to your STEPCRAFT system. Bigger cutters and much quieter. It really d...

I would not recommend using the pulley and grub screw to hold the spindle when you lock the lock nut. in my opinion - the best way is as follows ...

We don't like tool changes as it takes time and you have to re-zero 🙂 if you have time and patience it does not matter. But a general rule - its good...

can not open the files for pcnc. any other idea thanks in advance Wobbie - when we get our 840 we will setup all the parameters It seems there a...