check the manual - there is a table of LED status in there- see what that says. Haven't got one handy here so can't check. anyone here have a manual t...

Not quite that simple as the circuit is also in series with the X axis switch - so the circuit could already be broken here. you need to test for ...

I feel an after market mod coming on... 🙂

There are a number of settings when exporting. The top line / curve was the problem. There were a lot of points in it that were not needed - I just cl...

Looks like the DXF is the culprit. When asked to go outside the vector Cut2D produces a toolpath inside also. See "Cut2D toolpath difference". It seem...

I had tried the suspect files cutting into "air" and they had the same random behaviour. I have just done some cutting with UCCNC version 1.0031 an...

Let me quote some more. 🙂 Another good point - very important to verify the free movement of the machine in all areas of travel - but in thi...

One of the reasons I used a custom profile was that I had a slight problem with homing. Using the homing speeds in the default 600 profile the axis ho...

Don`t have any solutions, but couple of ideas. The following information could be completely irrelevant in this case. I see you have a laptop with ...

Tug - can you send files? If the Cut2D || Gcode || UCCNC process has been working well then there is no reason for this and there must be some expla...

Hi Dave - thanks for further information on this - so you have modified the profile from the profile we supplied to you? Can you check that the or...

Cheers Dave - interesting video. I've just ran the toolpath text file and it worked perfectly here. What is your PC setup? There is something funn...

looking forward to seeing the results. I think you will get much better results. The results on our larger router are much much better... but not sure...

G01 is machining instruction G00 is movement between cutting. looks good - well done!! One general comment on your video - your cutter is ...

okay - you've covered most points - please send some toolpaths to see can we reproduce what you are seeing.