Software used was V-carve Pro, 60 degree v-bit, 1mm end mill, 3mm spiral to cut out the outside. I ran a v-bit around the perimeter before final cut ...

YEs check for the closed circuit with multimeter - or you can short the inputs with a wire to act like a closed switch.

Very nice!!! out of interest - where exactly is that pin for PWM coming from? Through the SC card? Or via external source before going into main card?

Sow I'm making something like pic1 for a year now. But since two days it's doing something like pic2. When I run the machine manually, there is noth...

Finally, i'm somewhat disillusioned with the 3D printer. The 4th axe doesn't run; the PLA's flow observed came from only the internal pressure and sto...

Trying to use my recently built SC600 to 3D print. The problem I am having is that the material (PLA) seems to be feeding too quickly and interfering ...

M31.txt probe pin should be pin 10 (but check this before you test - so you should see pin 10 trigger when you press the tool length sensor). You...

Does it retract up into the limit switch? you can change this in the CAM? Safe Z?

Machining with a 2 flute - and then with a 1 flute - with the same parameters - means you are machining at "feed per tooth rate A" (2 flute) and "feed...

See does attached file work. NOTE: you should really have the Macros too (can't upload them to here for some reason)... send us an email. we have a...

Very impressive results. well done. that is an amazing result with the STEPPI!! if you read this thread - Julius has put in many many hours of tun...

Spring helps you out if the paper is not mounted flat. Post some pics of your results.

Watch that video - it could be the length of the ballscrew - if the ballscrew does not full seat then the two orange plates as they are squeezed toget...

Sander has the first position on the solution for this. We have a working probe profile that allows automated Z height setting. when time perm...

Solid state relays fail on don't use them... you need a charge pump system in the same circuit. charge pump circuit is only safe solution ...