remember with a V cutter - at the cutting tip... the cutting speed is in fact 0 RPM. So some part of the tip will, in theory, always be scratching. ...

Best strategy is not to play with the setup as you will have tuned it. mount a piece of MDF on the table. Drill and tap into the bed. Counter s...

To say the product does not meet the desired quality is not a fair statement without evidence as such. We have may guys who have got machines. Some ha...

The second thing to go wrong (because of working tired) I copied a larger tool in Vcarve to create a 3mm end mill but left the 9mm first path in the s...

Sounds like lost steps and the Z axis is loosing its position to it seems like its diving. If the cutter is lower than it should be then the Z axis is...

M6 bolts fits nice. use your steppi to make some clamps 🙂

Does the X work? all limits pop pin 12. so you can hit the Y axis limit as its homing in Z to "trick it". try this also.... wire in the Y ax...

V2 STEPCRAFT has 3000mm/min supported rapids. That is a website typo. If your machine is maxing out the feed rate and plnunge rate then the feed t...

Can you send us the Gcode file ?

Yes you can achieve this level of movement. Well done! She must be in good shape 😉 However - it gets very sensitive to setup and therefore you ar...

WinPC starter is not a Gcode controller - its can accept shapes in PLT format from Corel Draw. you need mach3 UCCNC WinPC USB to run the outpu...

Be careful. Increasing the power of the steppers allows you to push more power through the machine and you then get away with less tuning and the moto...

You can have a UCC100 no found for a number of reasons. IF there is any issue with the Micro USB then you can have connectivity issues. You need t...

its important that the bolt going through the orange plate into the extrusion module does not "catch". it should go into the tapped hole easy peasy. I...

Check the Z axis is free to move and well lubricated. Its important the axis does not loose steps when the axis is retracted upwards. Check the cu...