Hi Giles, Try running the UCCNC software in demo mode (usb disconnected) just to check that it all installed correctly. If not, you can downlo...

Hi Doug, Its a long time since we communicated - hope the guitar project is progressing well towards completion. My interest in the ballnut conversi...

I've now completed my first ball nut holder - and made all the jigs to allow the next "batch" to be made much more quickly and accurately. Material...

Hi Ben. I've used Eagle and pcb-gcode extensively for both single and double sided boards and have found the results extremely good. The zero re...

Hi Contact Rory at Stoney CNC - he is almost certain to be able to help one way or another. He may well have one in his spares stock. Peter

Make sure that all the swarf is continually cleared from the slot, otherwise it will build into a solid mass and either stall the axis or break the cu...

Why not describe your problem to Vectric - software bugs are not that rare!!

Hi Gaël , I bought the Industrial Grade spindle that StoneyCNC have developed to be Stepcraft compatible. Cannot praise it enough - mine has perfo...

Hi Gaël, That wasn't the only problem with mine - it sometimes wouldn't start when commanded by software, I got to be pretty damn quick on the "Jes...

Pity they didn't do that for the HF350 - mine developed square balls after about 30 hours of running WITH the air pump.

Hi Hassa, Replacement of the USB board with the parallel board is simply a matter of unplugging one and replacing with the other. You will also ne...

Hi Hassa, If you are going to change to UCCNC, then you will need to purchase a UC100 motion controller and a parallel interface card. The UC100 l...

Hi FaFiNoS, Perfect - thank you. All the critical information is there. Peter

Hi FaFiNoS, Thanks for the information - had some difficulty getting it into CUT2D - looks very odd on the screen, picture attached. I have mana...