The switches have already been proven to operate correctly by patching them into the ESD circuit - so it does point to a board fault rather than a swi...

Then it sounds very much like a hardware fault on the control board to me - unfortunately. If you are confident, can you check continuity between ...

Hi sgripp, Use the "Diagnostics" screen to see the state of the inputs as seen by UCCNC - you should be able to determine if the s/w is responding ...

Hi, Now done a few accuracy and repeatability tests on the sensor and M31 macro, and so far it has proven amazingly consistent. The target surfa...

Hi, Totally amazed!! It all worked first time - even the default M31 macro in V1.2xxx did the job without tweaking apart from adjusting the defaul...

That is quite disturbing, well worth raising a query with Vectric direct. I've concatenated toolpaths in Cut2D without problems, so I wonder where ...

On "Job Setup / XY Datum Position" is the "Use Offset" checked and non zero??

I've just measured masking tape alone and 2 layers of masking plus double sided tape. Each turn out to be 0.0045" +- .0002" - i.e. 0.114mm. Double...

Did - made a small one for pcb's out of scrap bits and pieces. Only cost was a decent vacuum pump!!!! Can mill/engrave 0.010" tracks accurately.

Or even put your double sided tape between the masking tape! 👿

Hi Richard, If you have access to a test meter, check that tripping the sensor actually produces a signal at the probe pin on the interface board. ...

Hi, I had the very same problem with my HF350. After spending a lot of time researching the problem, it came down to an occasional overcurrent sit...

Hi, This will be of little help to you, but my HF350 operates as expected under UCCNC V1.2 and UC100 so I doubt if it is a UCCNC problem. Peter

Check your M31 macro - if the Z axis stops when the sensor is triggered then the signal has been recognised by the UCCNC I/O software. Check that the...