Peter de Graaf
@peterdeg
Active Member
Beigetreten: Sep 1, 2021
Last seen: Jan 2, 2024
Themen: 1 / Antworten: 6
Antwort
Ball nut conversion - work in progress

Hi all, I am facing similar issue. I have a stepcraft D600 v2 with performance kit. I changed X and Z axis with the SKF ball nuts. The X axis works...

Vor 1 Jahr
Antwort
Ball Screw replacement for wearing thread nuts

Hi all, I have purchased the SKF bal bearings and replaced the X and Z axis. The Y axis are still not changed because for now that runs OK (perform...

Vor 1 Jahr
Antwort
Ball Screw replacement for wearing thread nuts

Hello, I would like to rebuild my stepcraft D600 (with performance kit) also with ball screws. I was wondering if you have model / drawing for the ...

Vor 1 Jahr
Antwort
D600 performance kit power supply

The mainboard and power supply was send for repair and i got it back yesterday. The machine is working again! Thanks for the good and quick support of...

Vor 2 Jahren
Forum
Topic
Forum
Replies: 1
Views: 2209
Antwort
D-Series Performance Kit

Hi, I had the same problem. Issue was the connector of the hal sensor. I needed to flip so that the wire colors are lining up the drawing provided. No...

Vor 3 Jahren
Forum
Antwort
Issue with the Y axis: is the belt worn out?

I had the same with my D600 v2 two times. the problem is that the set screws in the pulleys are coming loose because of vibrations. This will result i...

Vor 3 Jahren