I found that cleaning and lubricating the screws and guides solved the issue for me. Cheers, Per

Check the settings in UCCNC configuration as well. There is an option for how UCCNC should handle tool changes. Another thing to consider if you're po...

Good news! I've now found a solution to avoid the motors twitching when turning the spindle pump on/off. 1. A high quality line filter between t...

Hi Peter, I realize that I've taken a larger piece of the electronics cookie than I could swallow initially, but I don't think that the functionali...

I've now found one configuration where I at least can power up the vacuum machine using the relays and the pump manually. This configuration requir...

Thank you Peter for your suggestion! My colleague actually recommended something similar. I've conducted the following experiment today. 1. Remove ...

Peter, which pump is your system equipped with? Mine is from Hailea and the model is called ACO-208. From what I can tell it does not have any built i...

Hi Peter, I've checked that I have < 1 Ohm resistance from the protective earth (PE) ground on the power strip that I power the entire machine f...

Hi peterg1000, I've used the supplied grounding cable from Stepcraft as well and fastened it to the bottom of the chassis of the system. This ensur...

Hi Nonaga, If I were you I would consider supplying power to the pump from an outlet on a different fuse group in your home. This works for me, but...

I now understand what kind of wobble you were referring to. Tramming the spindle should improve it! Cheers, Per

Hi peterg1000, I may have misunderstood what you meant in your post and if that is the case you can just disregard my comments below. However, t...

I recently made the effort to tram my unit by shimming the base for the spindle holder relative to the z-axis. I found 0.5 and 1.0 degrees of tip / ti...