Patrascanu Sorin
@patrascanu
Active Member
Joined: Dez 25, 2016
Last seen: Mai 24, 2017
Topics: 2 / Replies: 10
Reply
motor y seem to get stuck and not moving smoothly

Yes, follow Peter's advices! My machine is ok now with UCCNC from Stepcraft (with UC 100 controller).

7 Jahren ago
Forum
Reply
Basic Mach3 configuration data

Confused and frustrated Stepcraft 420 with mach3 I read on here that ideal steps per Unit in motor tuning is 133.333333. I tested this on a 8...

8 Jahren ago
Topic
Forum
Replies: 0
Views: 3392
Reply
motor y seem to get stuck and not moving smoothly

I followed the steps and found several irregularities in the drive pulley. still hear strange noises and have to intervene. engine runs better now, it...

8 Jahren ago
Forum
Reply
motor y seem to get stuck and not moving smoothly

Thank you Doug, I will write to my dealer.

8 Jahren ago
Forum
Reply
motor y seem to get stuck and not moving smoothly

I checked the mechanics and that's okay. I disconnected the tooth belt and then I tested the engine. The problem is here: it works smoothly at very lo...

8 Jahren ago
Forum
Reply
motor y seem to get stuck and not moving smoothly

Sorry, I can not upload a video here, so I published it on youtube:

8 Jahren ago
Forum
Reply
8 Jahren ago
Forum
Reply
Topic
Forum
Replies: 17
Views: 10848
Reply
STEPCRAFT and Mach3

Big thanks for Rory! He sent me the Stepcraft Profile for Mach 3 and it works! Kind Regards!

8 Jahren ago
Forum