I've contacted Stepcraft support as was suggested in the link I posted above. They support asked me to double check my configuration and such but it d...

Hi Josh, Thanks for the feedback. I'll contact Stepcraft then after the Holidays. Cheers, Hatem

Cross referencing similar post:

I have the same issue as well but with UCCNC. Cross-referencing similar related post:

Hello guys, joshuarbailey87 wrote: > When I start a cycle, the Spindle won't auto start when it goes past the "S13000 M3" code. If I set it to ...

The file successfully loads in UCCNC, thanks :).