I found the problem! The key switch where the blue key is inserted seems to be a little sensitive. Apparently I was not turning it ON all the way. ...

Need Laser Profile please anybody send me the file to my mail ID [email protected] hi, check your email, spam folder if you do not see it...

Interesting - It would have taken me a while to get to an issue like that too. I'm glad you've come to a relatively simple problem that can be fixed....

I found the problem! The key switch where the blue key is inserted seems to be a little sensitive. Apparently I was not turning it ON all the way. ...

Frank, Stepcraft sent me the software right away and now the laser is working fine. Thanks again for your help on this matter. Regards

Frank, You were right. that was the problem. However I have another problem. when I run the test sequence the laser led does not illuminate at all....

Hi Stefan, Could you explain what resistors need to be exchanged against each other to get more current to the motors? I was considering upgrading ...