Very nice!!! out of interest - where exactly is that pin for PWM coming from? Through the SC card? Or via external source before going into main card?...

Very nice!!! out of interest - where exactly is that pin for PWM coming from? Through the SC card? Or via external source before going into main card?...

That looks like a belter, If you do get this one let me know how you get on with it please.

Hello Speedo, The weight of the motor plus adapter is: 1.1 Kg or 2.42 lbs

It is a bit of a squeeze to get in but could always make a replacement extended tool holder to remedy that. I've run it 3/4 to max and it's very quit...

Please see PDF file with dimensions attached below Spindleadapter-1.pdf

thanks tikka, It's been on for about 3 months now and I've not had trouble with motor clogging up with debris as yet, I can't say I've noticed any ...

Thanks and that's great nice going.

Varnished, but still need to get a pair of decent hinges.

This build can also be seen over at instructables.com please go check it out.

Hello hale2160, I bought my "satsuma 420" from Rory at StoneyCNC too in August 2014, managed to do quite a few bits and pieces with it which you ca...