The same thing happened with my HF500 spindle. It got harder and harder to turn and finally it was stuck. I buy a new HF500 spindel, but I do not us...

Thanks! This generally worked for me. I did have some questions/ideas though. 1. is there some way that if I use this command (I set to P1) t...

Sometimes it is simply just using what God gave us between the ears... After installing the 2nd Layer Module, everything worked like a charm just ...

Density 0,93 g/cm3 (DIN51757) Viscosity NLGI 2 This is on the grease in my link. Data sheet PTFE Grease. My Best Regards /Mika+

What do you think about PTFE Grease? PTFE Grease. I will order on of OKS 402 and try it. Can I use OKS 402 to the rollers as well? My best reg...

I have installed SKF Ball Screws in my Stepcraft 2-420, and I am not sure what lubricant I should use? :dry: My best regards /Mika+

I cut the cables and replaced with new ones and now all the axis work. It does not look so nice at the moment, but I can fix it when I have new parts...

Now I have changed the X motor to Z on the PCB and it work like a charm. I think it´s a fractured wire. /Mika+

One other thing I noticed is that the motor has a very high frequency of noise, the other motorss are completely silent. /Mika+

Thanks for your reply. Initially, I'll try to change the X or Y axis to Z to see that there is no error on the PCB. My fear is to rewire the gantr...

The motor has no power, and I can stop it with my fingers without any problems. No one has any idea what it might be wrong ??? /Mika+

This is a video of what happening. /Mika+