Lieber Nutzer, die Forumssoftware wurde aktualisiert. Für die Erstanmeldung musst Du bitte dein Passwort zurücksetzen.
Dear user, the forum software has been updated. For the first login please reset your password.
Dear user, the forum software has been updated. For the first login please reset your password.
![Manu FernandesVillela Manu FernandesVillela](http://stepcraft-systems.com/wp-content/uploads/wpforo/avatars/manufv@pt.lu_40750.png?lm=1721119541)
Manu FernandesVillela
@manufvpt-lu
Active Member
Beigetreten: Nov 21, 2019
Last seen: Apr 25, 2024
Last seen: Apr 25, 2024
Follow
Topic
Vor 2 Jahren
Forum
Replies: 0
Views: 1312
Topic
Antwort
Oscillating Tangential Knife OTK-3
Please check this
Vor 2 Jahren
Forum
Antwort
Adjusting X axis
Hi Radfort I get the same trouble. Eventually, do you found a solution ? Regards
Vor 2 Jahren
Forum
Antwort
OTK Tangential A-axis configuration on UCCNC
hi all, for share, I finally setup the OTK and good blade orientation. I use UCCNC 1.211x and I must define the screenset to default because the...
Vor 4 Jahren
Forum
Antwort
Laser will not start at all during a cycle
hi all, manu ok, solved.¨ I used UCCNC 1.2111, these release change the method to define CurrentHiLo. The input fields moved from I/OSetup to Ax...
Vor 4 Jahren
Forum
Antwort
ESTOP problem
Yes, I got the same. the trouble is when you put the laser into the holder. there is a little contacter which must be correctly plugged-in. on my m...
Vor 4 Jahren
Forum
Antwort
Laser will not start at all during a cycle
hi all, newbee with the laser, I get the same problem. - switch key ok, - vacuum on, ok - i/o setup & spindle configuration checked - Esto...
Vor 4 Jahren
Forum
Topic
Topic
Vor 5 Jahren
Replies: 0
Views: 3739