Ok when I machined ally on my 420, I knew plunging was an issue so 0.1mm is probably a good idea. I was machining a profile so i came in from outside...

I machined a 4 hour job without issues. Cutter breakage is usually from hitting clamps. (3mm cutter) As for missing steps that would most likely be ...

Rule of thumb is to support the milling cutter as much as possible into the collet. You have to be careful to allow for height of clamps and job thic...

To be fair the assembly time should not be an issue. If you are to identify every part of the machine in the process of assembling the machine then o...

First time change Blan The Genius I wasn't to happy with, So changed to Mr. B. then just recently couldn't remember password username etc. and though...