I had similar issues earlier, and it is not g-code issue, it is binding issue. The 3d printing does quite a lot of full speed moves around the part, a...

The G-code UCCNC accepts is documented in the UCCNCDocumentationUCCNC_usersmanual.pdf starting at page 40 (if using 1.0030 version of the software man...

For my 3mm 90 deg V-carve bit from stepcraft (SKU 10105 from) I have used following parameters: Diameter: 3.0 mm Included Angle: 90 Pass Depth 1....

If using default UCCNC configuration you always use Mach 2/3 Arcs (mm), regardless of the units you use in VCarve to draw the parts. Vcarve can use ei...

Easiest way to check Y-limit switch is to just open the side cover and manually trigger the micro switch. If you have UCCNC running it should immediat...

I also had problem where the belt was moving sideways on the tension support, and this was caused because the pulleys were not aligned. I.e. the Y axi...

If you have problems only when using real UCCNC, make sure that you have disabled the feature that puts some USB devices to power saving mode. I.e. wi...

Thats it for now. Most likely I do not have too much time to work with my stepcraft for next month or two, but we will see.

And I got some Tungsten cubes from another kickstarter project and decided to make stand for them. Everything went fine, I even managed to make 45 deg...

And then I made another present for my niece (goddaughter), and this time it was small box for holding things. Then I needed to make another fir her s...

Then some bases for homemade mustard jars.

And when you have hammer, all problems looks like nails, so when you are making Xmas card, you just print out picture, write some text with stepcraft ...

Some cutting boards with names.

Name tag for Bass.

Then some other random Xmas presents. First small fridge magnet.