Active Member
Beigetreten: Mrz 6, 2016
Last seen: Sep 29, 2016
Themen: 0 / Antworten: 15
Antwort
UCCNC changing zero point - error

It sounds like your Y axis stucked, a mechanical problem probably.

Vor 8 Jahren
Forum
Antwort
HF500 starts for no reason

Your multimeter is your friend helping you figuring out if there is really a signal which turns it on or if it is a problem with the spindle electroni...

Vor 8 Jahren
Forum
Antwort
Inconsistent stop of manual jogging

Is the position DRO of the axis still counting after the axis stopped and you keep pressing the jog button? If it does then it is not software but me...

Vor 8 Jahren
Forum
Antwort
Vor 8 Jahren
Forum
Antwort
Accessories for a PCB milling setup

I don't want to be a jerk with buying this off the OPs hands, but if DerRoy offering them for a good enough price then I would be interested to take i...

Vor 8 Jahren
Forum
Antwort
Accessories for a PCB milling setup

Don't hesitate to get the UC100 + UCCNC, it is a very good and easy to use control. The newest release have PCB leveling function built in, so you ca...

Vor 8 Jahren
Forum
Antwort
UCCNC UI rendering issues

I think you did not understand the concept. The UI is all changeable. There is a builtin screen editor in the software, so you could build any screen...

Vor 8 Jahren
Forum
Antwort
LIMITS using the UCNCC software

I never made a new profile. If I make a change in the settings I simply Apply and Save the settings with the blue buttons and the next run the softwar...

Vor 8 Jahren
Antwort
Fusion 360 post processor headaches

I did not use Fusion 360 yet, but thinking of trying it soon and wanted to ask what is the problem with running Fusion 360 with UCCNC? As far as I kn...

Vor 8 Jahren
Forum
Antwort
UCCNC reset logic issue

On the Diagnostics page check what causing the reset. It can be limit switches or e-stop or both. In demo mode I think it is reverse than how it is o...

Vor 9 Jahren
Forum
Antwort
UCCNC Backlash Settings?

The units in UCCNC are defined by the steps per value you setup for the axes. If your steps per values were setup for millimeters then one unit is on...

Vor 9 Jahren
Forum
Antwort
PROBLEM starting with UC100 with mach3 UCCNC in W7

The UC100 isn't just a USB to parallel converter it's actually a motion controller. So Mach3 can't do anything with the UC100 and the UCCNC softwar...

Vor 9 Jahren
Forum
Antwort
UCCNC 1.2

Hi, you are welcome. I was talking to the UCCNC developers the other day about this (I'm in the same country) and they told me it is not a bug, but a...

Vor 9 Jahren
Forum
Antwort
Vor 9 Jahren
Forum
Antwort
UCCNC 1.2

Press Enter after typing the profile name in and before pressing the create profile button.

Vor 9 Jahren
Forum