Make sure your "probe pin" is set to the pin you have connected the probe to. Should be pin 10. Go to the diagnostic screen and check that pin 10 is c...

Hi The UCCNC software has been up-issued at V1.1027 very recently. I wonder what's changed - must investigate this new version soon! Peter ...

Hi Rory I'm on version 1.0031, could I get the update as well? Cheers Hi, I'm having the same issue with the Backlash compensation on an 840 ma...

For some reason I can't edit my top comment. Bumping for new version as of 23 September 2015. - 1.1027

Great work, what is the material??

Amazing!

Great design looks good any chance you can share the files with us? yes, no problem 🙂 drawer-16mm.dxf.

Check here these instructions:

I hope you didn't kill the bearings :blink:

My problem was that I left out a golden ring, because they, apparently, came already mounted. But you have to remove the bearing and insert the ring i...

Hey, I made a Thien cyclone, it's easy to build and works perfect. Only needed some MDF, a 90º tube and a spare bucket. Check this video for how it...

I'll have to do something similar, dust is a problem, my vacuum gets clogged a lot.

Wow, I feel sorry for your end mill.

thanks!